2011-2013 Land Cruiser · Service Manual Engine / Hybrid / EV System

REPAIR

Removal / installation · Vehicles built Sep 2011 – Dec 2011


1. REPAIR INTAKE VALVE SEAT

NOTICE:
  1. Repair the seat while checking the seating position.
  2. Keep the lip free of foreign matter.
  3. Take off a cutter gradually to make the intake valve seat smooth.

  1. A053829E03
    Using a 45° cutter, resurface the valve seats.

    HINT:
    Only remove the amount of metal necessary to clean the seats.

  1. A053831E13
    If the seating is too high on the valve face:
    Use 30° and 45° cutters to correct the seat.

  1. A053832E12
    If the seating is too low on the valve face:
    Use 60° and 45° cutters to correct the seat.

  1. Check that the seat contact is in the middle of the valve face and has the following width.

    Standard width:
    1.0 to 1.4 mm (0.0394 to 0.0551 in.)

  1. A053833E01
    Hand-lap the valve and valve seat with an abrasive compound.

  1. Clean and check the valve seating position.


2. REPAIR EXHAUST VALVE SEAT

NOTICE:
  1. Repair the seat while checking the seating position.
  2. Keep the lip free of foreign matter.
  3. Take off a cutter gradually to make the exhaust valve seat smooth.

  1. A054350E03
    Using a 45° cutter, resurface the valve seats.

    HINT:
    Only remove the amount of metal necessary to clean the seats.

  1. A053831E13
    If the seating is too high on the valve face:
    Use 30° and 45° cutters to correct the seat.

  1. A053832E12
    If the seating is too low on the valve face:
    Use 60° and 45° cutters to correct the seat.

  1. Check that the seat contact is in the middle of the valve face and has the following width.

    Standard width:
    1.0 to 1.4 mm (0.0394 to 0.0551 in.)

  1. A054349E01
    Hand-lap the valve and valve seat with an abrasive compound.

  1. Clean and check the valve seating position.

← REASSEMBLY (Sep 2011 – Dec 2011)COMPONENTS (Sep 2011 – Dec 2011) →