2011-2013 Land Cruiser · Service Manual Brake

ON-VEHICLE INSPECTION

Inspection · Vehicles built from Sep 2011


CHECK BRK LP RELAY
  1. Remove the BRK LP relay from the engine room relay block.

  1. A087121E01
    Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    3 - 4
    Battery positive voltage applied to terminal 1 and battery negative voltage to terminal 2
    10 kΩ or higher
    Battery positive voltage not applied to terminal 1 and battery negative voltage applied to terminal 2
    Below 1 Ω
    3 - 5
    Battery positive voltage applied to terminal 1 and battery negative voltage to terminal 2
    Below 1 Ω
    Battery positive voltage not applied to terminal 1 and battery negative voltage applied to terminal 2
    10 kΩ or higher

    If the result is not as specified, replace the relay.

  1. Install the BRK LP relay.

← INSTALLATION (from Jan 2012)PRECAUTION (Sep 2011 – Dec 2011) →