REPLACEMENT
Removal / installation · Vehicles built from Sep 2011
| 1. DRAIN DIFFERENTIAL OIL |
Stop the vehicle on a level place.
for Front Differential:

Remove the engine under cover.
Using a 10 mm hexagon wrench, remove the filler plug and gasket.
Using a 10 mm hexagon wrench, remove the drain plug and gasket, and drain the oil.
Using a 10 mm hexagon wrench, install a new gasket and the drain plug.
- Torque:
- 39 N*m{ 400 kgf*cm , 29 ft.*lbf }
for Rear Differential:
Remove the filler plug and gasket.
Remove the drain plug and gasket, and drain the oil.
Install a new gasket and the drain plug.
- Torque:
- 49 N*m{ 500 kgf*cm , 36 ft.*lbf }
| 2. ADD DIFFERENTIAL OIL |
Add differential oil so that the oil level is between 0 to 5 mm (0 to 0.197 in.) from the bottom lip of the differential filler plug hole.

- NOTICE:
- Too much or too little oil will lead to differential problems.
- After changing the oil, drive the vehicle and then check the oil level again.
- Too much or too little oil will lead to differential problems.
- Front differential oil type and viscosity:
- Toyota Genuine Differential gear oil LT 75W-85 GL-5 or equivalent
- Rear Differential Oil Type and Viscosity:
Item
Oil Type and Viscosity
w/o LSD
Toyota Genuine Differential gear oil LT 75W-85 GL-5 or equivalent
w/ LSD
Toyota Genuine Differential gear oil LX 75W-85 GL-5 or equivalent
- Front differential capacity:
- 1.85 to 1.95 liters (1.96 to 2.06 US qts., 1.63 to 1.71 Imp. qts.)
- Rear Differential Capacity:
Item
Specified Condition
Standard
4.15 to 4.25 liters (4.39 to 4.49 US qts., 3.66 to 3.74 Imp. qts.)
w/ LSD
4.10 to 4.20 liters (4.34 to 4.43 US qts., 3.60 to 3.69 Imp. qts.)
w/ Differential lock
for Front Differential:
Using a 10 mm hexagon wrench, install a new gasket and the filler plug.
- Torque:
- 39 N*m{ 400 kgf*cm , 29 ft.*lbf }
Install the engine under cover.
for Rear Differential:
Install a new gasket and the filler plug.
- Torque:
- 49 N*m{ 500 kgf*cm , 36 ft.*lbf }
