2011-2013 Land Cruiser · Service Manual Engine / Hybrid / EV System

ON-VEHICLE INSPECTION

Inspection · Vehicles built from Sep 2011


CHECK DIESEL TURBO PRESSURE SENSOR

A163538E02
  1. Inspect the power source voltage.

    1. Disconnect the sensor connector.

    2. Measure the voltage according to the value(s) in the table below.

      Standard Voltage:
      Tester Connection
      Switch Condition
      Specified Condition
      C80-3 (VC) - C80-1 (E2)
      Engine switch on (IG)
      4.5 to 5.5 V

    3. Turn the engine switch off.

    4. Connect the sensor connector.

  1. Check the vacuum and pressure.

    1. Connect the intelligent tester to the DLC3.

    2. Turn the engine switch on (IG) and turn the intelligent tester on.

    3. Enter the following menus: Powertrain / Engine / Data List / Map and Atmosphere Pressure.

    4. Read the value.

      OK:
      Condition
      Map and Atmosphere Pressure Value
      No pressure applied
      Same as atmospheric pressure
      Vacuum applied
      Becomes vacuum
      Pressure applied
      Becomes pressurized

      If the result is not as specified, replace the sensor.

← COMPONENTS (from Sep 2011)REMOVAL (from Sep 2011) →