2011-2013 Land Cruiser · Service Manual Engine / Hybrid / EV System

ON-VEHICLE INSPECTION

Inspection · Vehicles built from Sep 2011


INSPECT POWER STEERING OIL PRESSURE SWITCH
  1. Check the oil pressure switch.

    1. Connect the intelligent tester to the DLC3.

    2. Turn the engine switch on (IG).

    3. Turn the intelligent tester main switch on.

    4. Enter the following menus: Powertrain / Engine and ECT / Data List / All Data / Power Steering pressure.

    5. Start the engine.

    6. Read the value displayed on the intelligent tester.

      OK:
      Condition
      Specified Condition
      Power steering operating
      ON
      Power steering not operating
      OFF

      If the result is not as specified, check the wire harness and connector. If the wire harness and connector are normal, replace the power steering oil pressure switch.

← COMPONENTS (from Jan 2012)REMOVAL (Sep 2011 – Dec 2011) →