2011-2013 Land Cruiser · Service Manual Engine / Hybrid / EV System

ON-VEHICLE INSPECTION

Inspection · Vehicles built Sep 2011 – Dec 2011

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012


INSPECT POWER STEERING OIL PRESSURE SWITCH
  1. Check the oil pressure switch.

    1. Connect the intelligent tester to the DLC3.

    2. Turn the ignition switch on (IG).

    3. Turn the intelligent tester on.

    4. Enter the following menus: Powertrain / Engine and ECT / Data List / Power Steering Switch.

    5. Start the engine.

    6. Operate the steering wheel while idling, and read the value on the Techstream.

      Standard:
      Condition
      Specified Condition
      Power steering not operating
      0 to 2 MPa
      Power steering operating
      Values change from above value

      If not as specified, check for DTCs (Click here). If the power steering system inspection results are normal and a DTC is not output, replace the power steering oil pressure switch.
      Inspect the power steering system (Click here). If the power steering system inspection results are normal and a DTC is not output, replace the power steering oil pressure switch.

← COMPONENTS (from Jan 2012)ON-VEHICLE INSPECTION (from Jan 2012) →