2011-2013 Land Cruiser · Service Manual Engine / Hybrid / EV System

ON-VEHICLE INSPECTION

Inspection · Vehicles built from Jan 2012


INSPECT POWER STEERING OIL PRESSURE SWITCH
  1. Connect the GTS to the DLC3.

  1. Turn the engine switch on (IG).

  1. Turn the GTS on.

  1. Enter the following menus: Powertrain / Engine and ECT / Data List / All Data / Power Steering Pressure.

  1. Start the engine.

  1. Operate the steering wheel while idling and read the value on the GTS.

    Standard:
    Measurement Condition
    Specified Condition
    Power steering not operating
    0 to 2000 kPa (0 to 20 kgf/cm2, 0 to 290 psi)
    Power steering operating
    Value changes from value displayed when power steering not operating

    If the result is not as specified, check for DTCs (Click here). If the power steering system inspection results are normal and a DTC is not output, replace the power steering oil pressure switch.

← COMPONENTS (from Jan 2012)REMOVAL (from Jan 2012) →