2011-2013 Land Cruiser · Service Manual Engine / Hybrid / EV System

ON-VEHICLE INSPECTION

Inspection · Vehicles built from Jan 2012


INSPECT VACUUM SWITCHING VALVE ASSEMBLY (for ACIS)
  1. Disconnect the vacuum switching valve connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    1 - 2
    20°C (68°F)
    37 to 44 Ω
    1 - Body ground
    Always
    1 MΩ or higher
    2 - Body ground

    If the result is not as specified, replace the vacuum switching valve assembly.

  1. Check the vacuum switching valve operation.

    1. A162111E02
      When applying a vacuum to port E, check that air is sucked into the filter.
      Text in Illustration 
      *1
      Filter
      *a
      Vacuum
      *b
      Air

    2. A162112E06
      Apply battery voltage to the connector, and check the VSV operation.

      OK:
      Measurement Condition
      Specified Condition
      Battery positive (+) → Terminal 1
      Battery negative (-) → Terminal 2
      Air is sucked into port E when a vacuum is applied to port F

      Text in Illustration 
      *a
      Vacuum
      *b
      Air
      If the result is not as specified, replace the vacuum switching valve assembly.

  1. Connect the vacuum switching valve connector.

← INSTALLATION (from Jan 2012)COMPONENTS (from Jan 2012) →