2011-2013 Land Cruiser · Service Manual Engine / Hybrid / EV System

INSPECTION

Inspection · Vehicles built from Sep 2011


INSPECT MASS AIR FLOW METER

  1. A165595E03
    Perform a visual check for any foreign matter on the platinum hot wire (heater) of the mass air flow meter shown in the illustration.

    OK:
    There is no foreign matter.

    Text in Illustration 
    *1
    Platinum Hot Wire (Heater)
    If the result is not as specified, replace the mass air flow meter.

  1. Check the intake air temperature sensor.

    A231278E01

    Text in Illustration 
    *1
    Resistance kΩ
    *2
    Temperature °C (°F)
    *3
    Acceptable Range
    -
    -
    *a
    Component without harness connected
    ( Mass air flow meter)
    -
    -

    1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance:
      Tester Connection
      Condition
      Specified Condition
      4 (THA) - 5 (E2)
      -20°C (-4°F)
      12.5 to 16.9 kΩ
      20°C (68°F)
      2.19 to 2.67 kΩ
      60°C (140°F)
      0.50 to 0.68 kΩ

      If the result is not as specified, replace the mass air flow meter.

← REMOVAL (from Sep 2011)INSTALLATION (from Sep 2011) →