2011-2013 Land Cruiser · Service Manual Engine / Hybrid / EV System

INSPECTION

Inspection · Vehicles built from Jan 2012


INSPECT MASS AIR FLOW METER ASSEMBLY

  1. Check the output voltage.

    1. A230350E01
      Apply battery voltage across terminals 1 (+B) and 2 (E2G).
      Text in Illustration 
      *a
      Component without harness connected
      (Mass Air Flow Meter)
      V100135
      Air

      NOTICE:
      While using the battery during inspection, do not bring the positive and negative tester probes too close to each other as a short circuit may occur.

    2. Using a voltmeter, connect the positive (+) tester probe to terminal 3 (VG) and the negative (-) tester probe to terminal 2 (E2G).

    3. Blow air into the mass air flow meter and check that the voltage fluctuates.
      If the result is not as specified, replace the mass air flow meter assembly.

  1. A230351E01
    Perform a visual check for any foreign matter on the platinum hot wire (heater) of the mass air flow meter shown in the illustration.

    OK:
    There is no foreign matter.

    Text in Illustration 
    *1
    Platinum Hot Wire (Heater)
    If the result is not as specified, replace the mass air flow meter assembly.

  1. Check the intake air temperature sensor.

    A231278E01

    Text in Illustration 
    *1
    Resistance
    *2
    Temperature
    *3
    Acceptable Range
    -
    -
    *a
    Component without harness connected
    (Mass Air Flow Meter)
    -
    -

    1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance:
      Tester Connection
      Condition
      Specified Condition
      4 (THA) - 5 (E2)
      -20°C (-4°F)
      12.5 to 16.9 kΩ
      4 (THA) - 5 (E2)
      20°C (68°F)
      2.19 to 2.67 kΩ
      4 (THA) - 5 (E2)
      60°C (140°F)
      0.50 to 0.68 kΩ

      If the result is not as specified, replace the mass air flow meter assembly.

← REMOVAL (from Jan 2012)INSTALLATION (from Jan 2012) →