REMOVAL
Removal / installation · Vehicles built from Jan 2012
- CAUTION:
- The exhaust pipe is extremely hot immediately after the engine has stopped.
- Confirm that the exhaust pipe has cooled down before removing it.
- The exhaust pipe is extremely hot immediately after the engine has stopped.
| 1. REMOVE PROPELLER SHAFT HEAT INSULATOR |
Remove the 2 bolts and insulator.

| 2. REMOVE HEATED OXYGEN SENSOR (for Bank 1 Sensor 2) |
Disconnect the heated oxygen sensor connector.

Using SST, remove the heated oxygen sensor from the front No. 2 exhaust pipe.

- SST
- 09224-00010
| 3. REMOVE HEATED OXYGEN SENSOR (for Bank 2 Sensor 2) |
Detach the clamp and disconnect the heated oxygen sensor connector.

Using SST, remove the heated oxygen sensor from the front exhaust pipe.

- SST
- 09224-00010
