REMOVAL
Removal / installation · Vehicles built Sep 2011 – Dec 2011
Versions by build date: Sep 2011 – Dec 2011 from Jan 2012
| 2.
REMOVE FRONT FENDER APRON SEAL FRONT RH
|
 |
- Remove the 3 clips and front fender apron seal front RH.
| 3.
REMOVE FRONT FENDER APRON SEAL REAR RH
|
 |
- Remove the 4 clips and front fender apron seal rear RH.
| 4.
REMOVE FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY LH
|
 |
Remove the 3 bolts and screw.
Turn the clip indicated by the arrow in the illustration to remove the fender splash shield.
| 5.
REMOVE FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY RH
|
 |
- HINT:
- Use the same procedures described for the LH side.
| 6.
REMOVE NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY
|
 |
- Remove the 10 bolts and under cover.
| 7.
DRAIN ENGINE OIL
|
 |
- Remove the 2 bolts and No. 2 engine under cover seal from the No. 2 engine under cover.
Remove the oil filler cap.
Remove the oil pan drain plug and gasket, and then drain the engine oil into a container.
Install a new gasket and the oil pan drain plug.
-
Torque:
- 38 N*m{
387 kgf*cm
, 28 ft.*lbf
}
| 8.
REMOVE NO. 2 ENGINE UNDER COVER
|
 |
- Remove the 2 bolts and under cover.
| 9.
DISCONNECT OIL COOLER TUBE (for Automatic Transmission) |
 |
- Remove the 3 bolts and disconnect the oil cooler tube from the engine.
| 10.
REMOVE ENGINE OIL LEVEL SENSOR |
 |
- Disconnect the sensor connector.
Remove the 4 bolts and sensor.
Remove the gasket from the sensor.