2011-2013 Land Cruiser · Service Manual Engine / Hybrid / EV System

P1607 Cruise Control Input Processor

Diagnostic trouble codes · Vehicles built from Jan 2012

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012

DESCRIPTION

The ECM continuously monitors its main and sub CPUs. This self-check ensures that the ECM is functioning properly. If outputs from the CPUs are different and deviate from the standard, the ECM will illuminate the MIL and store this DTC immediately.
DTC No.
DTC Detection Condition
Trouble Area
P1607
An ECM CPU is malfunctioning (1 trip detection logic).
ECM

INSPECTION PROCEDURE


1. CHECK FOR DTC
  1. Clear the DTCs (Click here).

  1. Turn the ignition switch off.

  1. Disconnect the cable from the negative (-) battery terminal and wait for 1 minute.

  1. Connect the cable to the negative (-) battery terminal.

  1. Turn the ignition switch to ON.

  1. Check for DTCs.

    OK:
    P1607 is not output.



NG
REPLACE ECM (Click here)
OK

CHECK FOR INTERMITTENT PROBLEMS (Click here)


← P1607 Cruise Control Input Processor (Sep 2011 – Dec 2011)P1613 Secondary Air Injection Driver Malfunction (from Jan 2012) →