2011-2013 Land Cruiser · Service Manual Vehicle Exterior

REMOVAL

Removal / installation · Vehicles built Sep 2011 – Dec 2011

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).


2. REMOVE FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY LH

B180991
  1. Remove the 3 bolts and screw.

  1. Turn the clip indicated by the arrow in the illustration to remove the fender splash shield.


3. REMOVE FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY RH

HINT:
Use the same procedures described for the LH side.


4. REMOVE UPPER RADIATOR SUPPORT SEAL
  1. for Gasoline Engine:
    Remove the upper radiator support seal (Click here).

  1. for Diesel Engine:
    Remove the upper radiator support seal (Click here).


5. REMOVE FRONT BUMPER WINCH COVER SUB-ASSEMBLY

6. REMOVE RADIATOR GRILLE ASSEMBLY

B180899E01
  1. Put protective tape around the radiator grille.

  1. Remove the 3 screws.

  1. Detach the 2 clips and 8 claws, and remove the radiator grille.


7. REMOVE FRONT BUMPER COVER

  1. Put protective tape around the bumper cover.

    B185485E01

  1. Using a T30 "TORX" socket, remove the 6 screws.

    B180994E01

  1. Remove the 3 clips, 4 screws and 4 bolts.

  1. Detach the 10 claws.

  1. w/o TOYOTA Parking Assist-sensor System, w/o Fog Light:
    Disconnect the winch control wire connector and remove the bumper cover.

  1. w/ TOYOTA Parking Assist-sensor System or w/ Fog Light:
    Disconnect the No. 4 engine room wire connector and winch control wire connector and remove the bumper cover.

    B185486


8. REMOVE FRONT BUMPER EXTENSION LH

B185487
  1. Remove the 3 bolts and bumper extension.


9. REMOVE FRONT BUMPER EXTENSION RH

HINT:
Use the same procedures described for the LH side.


10. REMOVE HEADLIGHT ASSEMBLY LH
  1. for Standard:
    Remove the headlight assembly LH (Click here).

  1. for HID Headlight:
    Remove the headlight assembly LH (Click here).


11. REMOVE HEADLIGHT ASSEMBLY RH

HINT:
Use the same procedures described for the LH side.


12. REMOVE FRONT UPPER CENTER BUMPER RETAINER

B185488
  1. Remove the 3 bolts and bumper retainer.


13. REMOVE RADIATOR SIDE DEFLECTOR LH

  1. A174322
    Using a clip remover, remove the 4 clips, and remove the side deflector.


14. REMOVE RADIATOR SIDE DEFLECTOR RH (w/o Oil Cooler)

  1. A174321
    Using a clip remover, remove the 4 clips, and remove the side deflector.


15. REMOVE TRANSMISSION OIL COOLER AIR DUCT (w/ Oil Cooler)

  1. A184326
    Remove the 4 bolts and oil cooler air duct.


16. REMOVE WINCH CONTROL WIRE

  1. B180480
    Remove the 2 nuts and winch control wire.


17. REMOVE WINCH ASSEMBLY

  1. B180484
    Remove the 9 bolts and mounting bracket.

  1. B185176
    Detach the 2 claws and move the cover in the direction indicated by the arrow shown in the illustration.

  1. B185177
    Disconnect the connector.

  1. Remove the nut and disconnect the wire.

  1. B180486
    Using a crane or equivalent, remove the winch assembly.

    CAUTION:
    Be careful as the winch assembly is very heavy.

← COMPONENTS (from Jan 2012)REMOVAL (from Jan 2012) →