INSTALLATION
Removal / installation · Vehicles built Sep 2011 – Dec 2011
Versions by build date: Sep 2011 – Dec 2011 from Jan 2012
| 1. INSTALL GASKET |
Clean the ECM seal surface with non-residue solvent.
Attach a new gasket to the ECM.
| 2. INSTALL ECM |
Install the ECM with the 4 bolts.
- Torque:
- 8.0 N*m{ 82 kgf*cm , 71 in.*lbf }
- NOTICE:
- Make sure the gasket is not folded or caught on any area of the surrounding part.
- Make sure there is no foreign matter caught between the gasket and surrounding part.
- Do not damage the gasket.
- Make sure the gasket is not folded or caught on any area of the surrounding part.
Connect the 2 ECM connectors and push each lock lever down to lock the ECM connectors.

- NOTICE:
- Be careful not to allow dirt, water, or other foreign matter to adhere to the connecting parts when connecting the connectors.
- Do not twist the wire harness when connecting the ECM connectors.
- Make sure that the lock levers are raised 90° before connecting the ECM connectors. Failure to do this may cause the lock lever and terminals to break.
- Make sure that the levers are securely locked.
- Be careful not to allow dirt, water, or other foreign matter to adhere to the connecting parts when connecting the connectors.
| 3. INSTALL CONNECTOR HOLDER BLOCK |
Install the connector holder block with the 3 bolts.
- Torque:
- 8.0 N*m{ 82 kgf*cm , 71 in.*lbf }
| 4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
- NOTICE:
- When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).
