2011-2013 Land Cruiser · Service Manual Engine / Hybrid / EV System

REMOVAL

Removal / installation · Vehicles built Sep 2011 – Dec 2011

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).


2. DISCONNECT CONNECTOR HOLDER BLOCK

  1. A183089E01
    Remove the 3 bolts and move the connector holder block so that the ECM can be removed in the next step.


3. REMOVE ECM

  1. A182753E01
    Raise the 2 levers while pushing the locks on the 2 levers.

    NOTICE:
    Make sure that the lock levers are raised 90° as shown in the illustration before disconnecting the ECM connectors. Failure to do this may cause the ECM connectors to break.

  1. Disconnect the 2 connectors.

  1. A155993
    Remove the 4 bolts and ECM.


4. REMOVE GASKET

  1. A167150
    Peel off the gasket.

  1. A185949E01
    Spray gasket remover or equivalent on the remaining tape of the gasket.

    NOTICE:
    When using gasket remover or equivalent, cover the ECM connectors with a cloth.

  1. A163829
    Remove the tape of the gasket without using bladed objects.

← COMPONENTS (from Sep 2011)REMOVAL (from Jan 2012) →