Removal / installation · Vehicles built Sep 2011 – Dec 2011
Versions by build date: Sep 2011 – Dec 2011from Jan 2012
1.
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
NOTICE:
When disconnecting the cable some systems need to be initialized after the cable is reconnected (Click here).
2.
DISCONNECT CONNECTOR HOLDER BLOCK
Remove the 3 bolts and move the connector holder block so that the ECM can be removed in the next step.
3.
REMOVE ECM
Raise the 2 levers while pushing the locks on the 2 levers.
NOTICE:
Make sure that the lock levers are raised 90° as shown in the illustration before disconnecting the ECM connectors. Failure to do this may cause the ECM connectors to break.
Disconnect the 2 connectors.
Remove the 4 bolts and ECM.
4.
REMOVE GASKET
Peel off the gasket.
Spray gasket remover or equivalent on the remaining tape of the gasket.
NOTICE:
When using gasket remover or equivalent, cover the ECM connector with a cloth.
Remove the tape of the gasket without using bladed objects.