REMOVAL
Removal / installation · Vehicles built Sep 2011 – Dec 2011
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
- CAUTION:
- Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable SRS system.
- NOTICE:
- When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).
| 2. DISCONNECT CONNECTOR HOLDER BLOCK |
Remove the 3 bolts and move the connector holder block so that the ECM can be removed in the next step.

| 3. REMOVE ECM |
Raise the 2 levers while pushing the locks on the 2 levers.

- NOTICE:
- Make sure that the lock levers are raised 90° as shown in the illustration before disconnecting the ECM connectors. Failure to do this may cause the ECM connectors to break.
Disconnect the 2 connectors.
Remove the 4 bolts and ECM.

| 4. REMOVE GASKET |
Peel off the gasket.

Spray gasket remover or equivalent on the remaining tape of the gasket.

- NOTICE:
- When using gasket remover or equivalent, cover the ECM connectors with a cloth.
Remove the tape of the gasket without using bladed objects.

