2011-2013 Land Cruiser · Service Manual Audio / Visual / Telematics

DTC CHECK / CLEAR

Troubleshooting · Vehicles built from Jan 2012


CHECK DTC
  1. Connect the intelligent tester to the DLC3.

  2. Turn the engine switch on (IG).

  3. Turn the intelligent tester on.

  4. Enter the following menus: Body / Navigation System / DTC.

  5. Check for DTCs and then write them down.

  6. Check for DTCs (Click here).

    NOTICE:
    The navigation system outputs DTCs for the following system. When DTCs other than those in Diagnostic Trouble Code Chart for the navigation system are output, refer to Diagnostic Trouble Code Chart for the relevant system.
    System
    Proceed to
    Navigation system
    Click here


CLEAR DTC
  1. Connect the intelligent tester to the DLC3.

  2. Turn the engine switch on (IG).

  3. Turn the intelligent tester on.

  4. Enter the following menus: Body / Navigation System / DTC.

  5. Clear the DTCs.

← DIAGNOSIS SYSTEM (from Jan 2012)DATA LIST / ACTIVE TEST (from Jan 2012) →