CUSTOMIZE PARAMETERS
Troubleshooting · Vehicles built from Jan 2012
Versions by build date: Sep 2011 – Dec 2011 from Jan 2012
| CUSTOMIZING FUNCTION WITH INTELLIGENT TESTER |
- HINT:
- The following items can be customized.
- NOTICE:
- When the customer requests a change in a function, first make sure that the function can be customized.
- Be sure to make a note of the current settings before customizing.
- When troubleshooting a function, first make sure that the function is set to the default setting.
- When the customer requests a change in a function, first make sure that the function can be customized.
Connect the intelligent tester to the DLC3.
Turn the engine switch on (IG).
Turn the intelligent tester on.
Enter the following menus: Customize Setting /
Select the setting by referring to the table below.
Warning Display
Default
Contents
Setting
Rr Sensor Onset Range
Wide
Sets the buzzer activation range for the rear sensors.
Narrow or Wide
Keep Sense Buzzer
Avail
Makes the buzzer sound when the distance between the vehicle and obstacle does not change for more than 3 seconds.
Not Avail or Avail
Fr & Rr Buzzer Volume
H
Changes the buzzer volume setting.
L, M1, M2, M3 or H
Sensor Display
Default
Contents
Setting
Sensor Condition N
Avail
Makes the sensors available when the shift lever is in N.
Not Avail or Avail
Front Side Dist Sensor
Long
Sets the buzzer activation range for the front sensors.
Short or Long
Reverse Range Front Sensor
Fsde
Changes the operation setting for the vehicle front sensors when the shift lever is in R.
F, Fs,Fc, Fsde or F Stop
Non P/R Range Rear Sensor
R Stop
Changes the operation setting for the vehicle rear sensors when the shift lever is not in P or R.
R, Rcrn or R Stop
Display Display
Default
Contents
Setting
Approach Display OFF
Avail
The display when moving away from a previously detected obstacle.
Not Avail or Avail
Display Mode
All
The display mode setting (when the intuitive parking assist system is normal).
All or Undisp
| CUSTOMIZING FUNCTION WITH MULTI-DISPLAY (w/ Multi-display) |
- HINT:
- The following items can be customized.
- NOTICE:
- When the customer requests a change in a function, first make sure that the function can be customized.
- Be sure to make a note of the current settings before customizing.
- When troubleshooting a function, first make sure that the function is set to the default setting.
- When the customer requests a change in a function, first make sure that the function can be customized.
Turn the engine switch on (IG).
Enter the following menus: Setup / Vehicle / TOYOTA park assist.
Select the setting by referring to the table below.
Warning Display
Default
Contents
Setting
Alert volume
3
Sets the buzzer activation range for the rear center sensors.
1, 2, 3, 4 or 5
Display
On
The display mode setting (when the TOYOTA parking assist-sensor system is normal).
On or Off
Distance
Wide
Sets the buzzer activation range for the rear center sensors.
Narrow or Wide