Removal / installation · Vehicles built Sep 2011 – Dec 2011
Versions by build date: Sep 2011 – Dec 2011from Jan 2012
1.
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL (for HID Headlight)
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).
2.
REMOVE FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY LH
Remove the 3 bolts and screw.
Turn the clip indicated by the arrow in the illustration to remove the fender splash shield.
3.
REMOVE FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY RH
HINT:
Use the same procedures described for the LH side.
4.
REMOVE UPPER RADIATOR SUPPORT SEAL
Remove the 7 clips and radiator support seal.
5.
REMOVE RADIATOR GRILLE ASSEMBLY
Put protective tape around the radiator grille.
Remove the 3 screws.
Detach the 2 clips and 8 claws, and remove the radiator grille.
6.
REMOVE FRONT BUMPER COVER
HINT:
For the front bumper cover with garnish, use the procedures described below.
Put protective tape around the bumper cover.
Using a T30 "TORX" socket, remove the 6 screws.
Remove the 3 clips, 4 screws and 4 bolts.
w/o TOYOTA Parking Assist-sensor System, w/o Fog Light: Detach the 10 claws and remove the bumper cover.
w/ TOYOTA Parking Assist-sensor System or w/ Fog Light: Detach the 10 claws, disconnect the No. 4 engine room wire connector and remove the bumper cover.
w/ Headlight Cleaner System: Disconnect the headlight cleaner hose and remove the bumper cover.
7.
REMOVE FRONT BUMPER ENERGY ABSORBER
Remove the energy absorber.
8.
REMOVE FRONT BUMPER REINFORCEMENT SUB-ASSEMBLY
Remove the 6 nuts and reinforcement.
9.
REMOVE FRONT NO. 2 BUMPER EXTENSION SUB-ASSEMBLY LH
Remove the 4 nuts and bumper extension.
10.
REMOVE FRONT NO. 2 BUMPER EXTENSION SUB-ASSEMBLY RH
HINT:
Use the same procedures described for the LH side.
11.
REMOVE FRONT BUMPER SIDE SUPPORT LH
Remove the 2 screws.
Detach the 3 clips and remove the side support.
12.
REMOVE FRONT BUMPER SIDE SUPPORT RH
HINT:
Use the same procedures described for the LH side.
13.
REMOVE HEADLIGHT ASSEMBLY LH
for Standard: Remove the headlight assembly LH (Click here).
for HID Headlight: Remove the headlight assembly LH (Click here).
14.
REMOVE HEADLIGHT ASSEMBLY RH
HINT:
Use the same procedures described for the LH side.