REASSEMBLY
Removal / installation · Vehicles built from Sep 2011
| 1. INSTALL REAR NO. 2 STEP COVER (w/ Towing Hitch) |
Attach the 4 claws to install the rear No. 2 step cover.
Install the 2 screws and 2 clips.
| 2. INSTALL REAR LOWER BUMPER COVER (w/ Towing Hitch) |
Install the rear lower bumper cover with the clip.
| 3. INSTALL REAR NO. 2 STEP COVER (w/ Pintle Hook) |
Attach the 10 claws to install the rear No. 2 step cover.
| 4. INSTALL REAR BUMPER PAD LH |
- HINT:
- When installing the rear bumper pad, heat the rear bumper cover using a heat light.
- Standard:
Item
Temperature
Rear Bumper Cover
20 to 30°C (68 to 86°F)
- NOTICE:
- Do not heat the rear bumper cover excessively.
When using a new rear bumper cover:
Clean the surface of a new rear bumper cover.
Using a heat light, heat the rear bumper cover surface.
When reusing the rear bumper cover:
Using a heat light, heat the rear bumper cover surface.
Remove the double-sided tape from the rear bumper cover.
Wipe off any tape adhesive residue with cleaner.
Install a new rear bumper pad.

Remove the peeling paper from the face of a new rear bumper pad.
- HINT:
- After removing the peeling paper, keep the exposed adhesive free from foreign matter.
Align the rear bumper pad with the mark-off line of the rear bumper.
Install the rear bumper pad.
| 5. INSTALL REAR BUMPER PAD RH |
- HINT:
- Use the same procedure described for the LH side.
| 6. INSTALL BACK-UP LIGHT ASSEMBLY LH |
Attach the claw to install the back-up light assembly LH.
Install the 2 nuts.
| 7. INSTALL BACK-UP LIGHT ASSEMBLY RH |
- HINT:
- Use the same procedure described for the LH side.
| 8. INSTALL REAR BUMPER NO. 2 SIDE BRACKET (w/ Tire Carrier) |
Attach the 3 claws to install the rear bumper No. 2 side bracket.
| 9. INSTALL REAR BUMPER NO. 3 SIDE BRACKET (w/ Tire Carrier) |
Install the rear bumper No. 3 side bracket with the 2 screws.
| 10. INSTALL REAR BUMPER UPPER COVER LH |
Attach the 4 claws to install the rear bumper upper cover.
| 11. INSTALL REAR BUMPER UPPER COVER RH |
- HINT:
- Use the same procedure described for the LH side.
| 12. INSTALL REAR BUMPER ENERGY ABSORBER |
Attach the 8 claws to install the rear bumper energy absorber.
| 13. INSTALL NO. 2 FRAME WIRE |
Attach the 13 clamps to install the No. 2 frame wire.
Connect the 2 connectors.
