2011-2013 Land Cruiser · Service Manual Vehicle Exterior

INSTALLATION

Removal / installation · Vehicles built Sep 2011 – Dec 2011

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012

HINT:
  1. Use the same procedures for the RH side and LH side.
  2. The procedures listed below are for the LH side.


1. INSTALL FRONT DOOR BELT MOULDING ASSEMBLY LH

B182604
  1. Attach the claw to install the belt moulding.


2. INSTALL FRONT DOOR GLASS RUN LH

  1. B180838
    Install the front door glass run.


3. INSTALL FRONT DOOR GLASS SUB-ASSEMBLY LH

  1. B183141
    Insert the door glass into the door panel along the glass run as indicated by the arrows in the illustration.

    NOTICE:
    Be careful not to damage the glass.

  1. B180832
    Install the door glass to the window regulator with the 2 bolts.

    Torque:
    8.0 N*m{ 82 kgf*cm , 71 in.*lbf }


4. INSTALL FRONT INNER DOOR GLASS WEATHERSTRIP LH
  1. Install the front inner door glass weatherstrip LH.


5. INSTALL FRONT DOOR SERVICE HOLE COVER LH

  1. B180831
    Apply butyl tape to the door.

  1. Pass the front door lock remote control cable and front door inside locking cable through a new front door service hole cover.

    NOTICE:
    1. When installing the service hole cover, pull the links and connectors through the service hole cover.
    2. There should be no wrinkles or folds after attaching the service hole cover.
    3. After attaching the service hole cover, check the sealing quality.

  1. B186231E01
    Connect the 2 connectors.

  1. Attach the 9 clamps.

  1. Install the bolt as shown in the illustration.

    Torque:
    8.4 N*m{ 86 kgf*cm , 74 in.*lbf }


6. INSTALL OUTER REAR VIEW MIRROR ASSEMBLY LH

B180573E01
  1. Attach the claw and Install the mirror with the 3 nuts.

    Torque:
    8.0 N*m{ 82 kgf*cm , 71 in.*lbf }

  1. w/ Power Mirror Control System:

    1. Attach the clamp.

    2. Connect the connector labeled A.


7. INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH
  1. Connect the connector.

  1. B183139
    Connect the front door lock remote control cable and front door inside locking cable to the front door inside handle sub-assembly.

  1. B180821
    Attach the 4 claws and 13 clips to install the front door trim board sub-assembly.

  1. Install the 3 screws.


8. INSTALL DOOR ASSIST GRIP COVER LH

  1. B183138
    Attach the 8 claws to install the door assist grip cover to the door trim panel.


9. INSTALL FRONT DOOR ARMREST BASE PANEL ASSEMBLY LH
  1. Connect the connector.

  1. B183137
    Attach the 5 claws to install the armrest base panel.


10. INSTALL FRONT DOOR INSIDE HANDLE BEZEL LH

  1. B183136
    Attach the 4 claws to install the bezel.


11. INSTALL FRONT LOWER DOOR FRAME BRACKET GARNISH LH

  1. B180820
    Attach the clip and claw, and install the front door lower frame bracket garnish.


12. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).

← REMOVAL (from Jan 2012)INSTALLATION (from Jan 2012) →