2011-2013 Land Cruiser · Service Manual Vehicle Exterior

REMOVAL

Removal / installation · Vehicles built from Jan 2012

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012

HINT:
  1. Use the same procedure for the RH and LH sides.
  2. The procedure listed below is for the LH side.


1. REMOVE REAR COMBINATION LIGHT ASSEMBLY LH

  1. E244781E01
    Using a screwdriver wrapped with protective tape, detach the 6 claws and remove the 2 cover.
    Text in Illustration 
    *1
    Protective Tape

  1. E244782E01
    Put protective tape around the rear combination light assembly LH.
    Text in Illustration 
    *1
    Protective Tape

  1. Remove the 2 bolts.

  1. Detach the 2 clips and remove the rear combination light assembly LH.

  1. Disconnect the connector.


2. REMOVE REAR COMBINATION LIGHT GASKET LH
  1. Remove the rear combination light gasket LH from the rear combination light lens and body LH.


3. REMOVE REAR TURN SIGNAL LIGHT BULB

  1. E244783
    Detach the clamp.

  1. Turn the socket in the direction indicated by the arrow in the illustration and remove the socket and rear turn signal light bulb.

  1. Remove the rear turn signal light bulb from the socket.

← REMOVAL (Sep 2011 – Dec 2011)DISASSEMBLY (Sep 2011 – Dec 2011) →