ON-VEHICLE INSPECTION
Inspection · Vehicles built from Sep 2011
| INSPECT HEADLIGHT RELAY (HEAD HI, HEAD LO) |
Remove the headlight relay from the engine room relay box.

Measure the resistance according to the value(s) in the table below.

- Standard Resistance:
Tester Connection
Condition
Specified Condition
3 - 5
When battery voltage is not applied to terminals 1 and 2
10 kΩ or higher
When battery voltage is applied to terminals 1 and 2
Below 1 Ω
Install the headlight relay to the engine room relay box.
| INSPECT FOG LIGHT RELAY (FR FOG) |
Remove the fog light relay from the engine room relay box.

Measure the resistance according to the value(s) in the table below.

- Standard Resistance:
Tester Connection
Condition
Specified Condition
3 - 5
When battery voltage is not applied to terminals 1 and 2
10 kΩ or higher
When battery voltage is applied to terminals 1 and 2
Below 1 Ω
Install the fog light relay to the engine room relay box.
| INSPECT STOP LIGHT CONTROL RELAY ASSEMBLY |
w/ Floor Under Cover:
Remove the No. 1 under cover (Click here).
Measure the voltage according to the value(s) in the table below.

- Standard Voltage:
Tester Connection
Switch Condition
Specified Condition
A39-6 (+B) - A39-4 (GND)
Always
11 to 14 V
A39-2 (STP) - Body grand
Stop light switch on
11 to 14 V
Stop light switch off
Below 1 V
A39-8 (OUT) - Body grand
Stop light switch on
11 to 14 V
Stop light switch off
Below 1 V
w/ Floor Under Cover:
Install the No. 1 under cover (Click here).
