2011-2013 Land Cruiser · Service Manual Vehicle Interior

REMOVAL

Removal / installation · Vehicles built from Sep 2011

HINT:
  1. Use the same procedures for LHD and RHD vehicles.
  2. The procedures listed below are for LHD vehicles.


1. REMOVE FRONT LOWER DOOR FRAME BRACKET GARNISH LH

  1. B180820
    Detach the clip and claw, remove the front lower door frame bracket garnish.


2. REMOVE FRONT DOOR INSIDE HANDLE BEZEL LH

  1. B180816
    Using a screwdriver, detach the 4 claws and remove the inside handle bezel.

    HINT:
    Tape the screwdriver tip before use.


3. REMOVE FRONT DOOR ARMREST BASE PANEL ASSEMBLY LH

B180817
  1. Using a moulding remover, detach the 5 claws.

  1. Disconnect the connector and remove the armrest base panel.


4. REMOVE DOOR ASSIST GRIP COVER LH

  1. B180819
    Using a moulding remover, detach the 8 claws and remove the door assist grip cover.


5. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH

  1. B180821
    Remove the 3 screws.

  1. Remove the 13 clips, 4 claws and trim board.

  1. Disconnect the connector.

  1. B180822
    Disconnect the 2 cables from the inside handle.


6. REMOVE SEAT MEMORY SWITCH

B180823
  1. Disconnect the connector.

  1. Remove the screw and seat memory switch.

← COMPONENTS (from Sep 2011)INSPECTION (from Sep 2011) →