2011-2013 Land Cruiser · Service Manual Vehicle Interior

REMOVAL

Removal / installation · Vehicles built Sep 2011 – Dec 2011

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012

HINT:
  1. Use the same procedures for the LH side and RH side.
  2. The procedures listed below are for the LH side.


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).


2. REMOVE REAR DOOR ARMREST BASE PANEL ASSEMBLY LH

  1. B180908
    Using a moulding remover, detach the 7 claws.

  1. Disconnect the connector and remove the armrest base panel.


3. REMOVE REAR DOOR INSIDE HANDLE BEZEL LH

  1. B180907E01
    Using a screwdriver, detach the 4 claws and remove the bezel.

    HINT:
    Tape the screwdriver tip before use.

    Text in Illustration 
    *1
    Protective tape


4. REMOVE ASSIST GRIP COVER LH

  1. B180910
    Using a moulding remover, detach the 9 claws and remove the door assist grip cover.


5. REMOVE COURTESY LIGHT ASSEMBLY (w/ Courtesy Light)

  1. E155902
    Detach the claw.

  1. Remove the courtesy light and then disconnect the connector.


6. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY LH

  1. B180912
    Remove the 3 screws.

  1. Remove the 9 clips, 4 claws and trim board.

  1. Disconnect the connector and remove the trim board.

  1. B180913
    Disconnect the 2 cables from the inside handle.


7. REMOVE REAR DOOR SERVICE HOLE COVER LH

  1. B183933E01
    Using a clip remover, detach the 6 clamps.

  1. Remove the bolt and disconnect the 2 connectors.

  1. Remove the service hole cover.

    HINT:
    Remove the remaining tape on the door.


8. REMOVE REAR DOOR LOCK ASSEMBLY LH

  1. B180926
    Using a T30 ''TORX'' socket, remove the 3 screws and door lock.

    NOTICE:
    Be careful when removing the screws as the door lock may fall and become damaged.


9. REMOVE REAR DOOR OUTSIDE HANDLE COVER LH

  1. B185067
    Using a T30 ''TORX'' socket, loosen the screw.

  1. B185061
    Detach the claw and remove the rear door outside handle cover.


10. REMOVE REAR DOOR OUTSIDE HANDLE ASSEMBLY LH

  1. B180934
    Using a T30 "TORX" wrench, loosen the screw.

  1. Disconnect the connector.

  1. B180933
    Remove the handle by sliding and pulling it in the direction indicated by the arrow in the illustration.

← COMPONENTS (from Sep 2011)REMOVAL (from Jan 2012) →