INSTALLATION
Removal / installation · Vehicles built from Jan 2012
| 1. INSTALL ENGINE OIL LEVEL SENSOR |
Install a new gasket and the oil level sensor with the 4 bolts.
- Torque:
- 7.0 N*m{ 71 kgf*cm , 62 in.*lbf }
Connect the oil level sensor connector.
| 2. CONNECT OIL COOLER PIPE ASSEMBLY |
Connect the oil cooler pipe with the 2 bolts.
- Torque:
- 14 N*m{ 143 kgf*cm , 10 ft.*lbf }
| 3. ADD ENGINE OIL |
Add fresh oil and install the oil filler cap.
- Standard Oil Grade:
Oil Grade
Oil Viscosity (SAE)
API grade SL "energy-conserving", API grade SM "energy-conserving" or ILSAC multigrade engine oil
5W-30
10W-30
API grade SL and SM multigrade engine oil
15W-40
20W-50
- Standard Oil Capacity:
Item
Specified Condition
Drain and refill without oil filter change
7.1 liters (7.5 US qts, 6.2 Imp. qts)
Drain and refill with oil filter change
7.5 liters (7.9 US qts, 6.6 Imp. qts)
Dry fill
9.3 liters (9.8 US qts, 8.2 Imp. qts)
| 4. INSPECT FOR OIL LEAK |
Start the engine. Make sure that there are no oil leaks from the area that was worked on.
| 5. INSPECT ENGINE OIL LEVEL |
Warm up the engine, stop the engine and wait 5 minutes. The oil level should be between the dipstick low level mark and full level mark.
If low, check for leakage and add oil up to the full level mark.- NOTICE:
- Do not fill engine oil above the full level mark.
| 6. INSTALL NO. 2 ENGINE UNDER COVER |
Install the No. 2 engine under cover with the 2 bolts.
- Torque:
- 29 N*m{ 296 kgf*cm , 21 ft.*lbf }
| 7. INSTALL NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY |
Install the No. 1 engine under cover with the 10 bolts.
- Torque:
- 29 N*m{ 296 kgf*cm , 21 ft.*lbf }
| 8. INSTALL FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY LH |
Push in the clip to install the front fender splash shield sub-assembly LH.
Install the 3 bolts and screw.
| 9. INSTALL FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY RH |
Push in the clip to install the front fender splash shield sub-assembly RH.
Install the 3 bolts and 2 screws.
