2011-2013 Land Cruiser · Service Manual Audio / Visual / Telematics

INSPECTION

Inspection · Vehicles built from Jan 2012

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012


INSPECT BACK SONAR OR CLEARANCE SONAR SWITCH ASSEMBLY

  1. E245465E01
    Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    6 (IG) - 9 (ECU)
    Back sonar or clearance sonar switch assembly on
    Below 1 Ω
    6 (IG) - 9 (ECU)
    Back sonar or clearance sonar switch assembly off
    10 kΩ or higher

    Text in Illustration 
    *1
    Component without harness connected
    (Back Sonar or Clearance Sonar Switch assembly)
    If the result is not as specified, replace the back sonar or clearance sonar switch assembly.

  1. E245465E02
    Check that the switch indicator.

    1. Apply battery voltage to the blind spot monitor main switch (integration control and panel assembly) and check the operation of the switch as shown in the table below.

      OK:
      Tester Connection
      Specified Condition
      Battery positive (+) → Terminal 6 (IG)
      Battery negative (-) → Terminal 10 (IND)
      Illuminates

      Text in Illustration 
      *1
      Component without harness connected
      (Back Sonar or Clearance Sonar Switch assembly)

  1. E245465E03
    Check that the switch illuminates.

    1. Apply battery voltage to the back sonar or clearance sonar switch assembly and check that the switch illuminates.

      OK:
      Tester Connection
      Specified Condition
      Battery positive (+) → Terminal 8 (ILL+)
      Battery negative (-) → Terminal 7 (ILL-)
      Illuminates

      Text in Illustration 
      *a
      Component without harness connected
      (Back Sonar or Clearance Sonar Switch Assembly)
      If the result is not as specified, replace the back sonar or clearance sonar switch assembly.

← INSPECTION (Sep 2011 – Dec 2011)INSTALLATION (Sep 2011 – Dec 2011) →