REMOVAL
Removal / installation · Vehicles built Sep 2011 – Dec 2011
Versions by build date: Sep 2011 – Dec 2011 from Jan 2012
- HINT:
- Use the same procedures for the LHD vehicle and RHD vehicle.
- The procedures listed below are for the LHD vehicle.
- Use the same procedures for the LHD vehicle and RHD vehicle.
| 1. REMOVE NO. 2 INSTRUMENT PANEL FINISH PANEL CUSHION |
![]() ![]() |
Put protective tape around the No. 2 instrument panel finish panel cushion.
Text in Illustration *1
Protective Tape
Using a moulding remover, detach the 7 claws and remove the No. 2 instrument panel finish panel cushion.
| 2. REMOVE LOWER INSTRUMENT PANEL PAD SUB-ASSEMBLY LH |
![]() ![]() |
Remove the clip and screw.
Detach the 8 claws.
Disconnect the connectors, detach the 2 clamps and remove the lower instrument panel pad sub-assembly.
| 3. REMOVE NO. 1 INSTRUMENT CLUSTER FINISH PANEL GARNISH |
![]() ![]() |
Place protective tape as shown in the illustration.
Text in Illustration *1
Protective Tape
Using a moulding remover, detach the 3 claws and remove the No. 1 instrument cluster finish panel garnish.
| 4. REMOVE NO. 2 INSTRUMENT CLUSTER FINISH PANEL GARNISH |
Place protective tape as shown in the illustration.
Using a moulding remover, detach the 2 claws and remove the No. 2 instrument cluster finish panel garnish.


Text in Illustration *A
w/ Entry and Start System
*B
w/o Entry and Start System
*1
Protective Tape
-
-
| 5. REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (w/ Floor Under Cover) |
![]() ![]() |
Remove the 2 screws.
Detach the 3 claws.
Disconnect the connectors and remove the No. 1 instrument panel under cover.
| 6. REMOVE NO. 1 SWITCH HOLE BASE |
![]() ![]() |
Detach the 4 claws.
Disconnect the connectors and remove the No. 1 switch hole cover.
| 7. REMOVE LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL |
![]() ![]() |
Using a screwdriver, detach the 2 claws and open the hole cover.
- HINT:
- Tape the screwdriver tip before use.
Text in Illustration *1
Protective Tape
w/ Driver Side Knee Airbag:
Remove the 2 bolts.
Detach the 16 claws.


w/o Driver Side Knee Airbag:
Remove the 2 bolts.
Detach the 9 claws.


for Automatic Air Conditioning System:

Detach the 2 claws and remove the room temperature sensor.
Detach the 2 claws and disconnect the 2 control cables.

Disconnect the connectors and remove the lower No. 1 instrument panel finish panel.
| 8. REMOVE ROOM TEMPERATURE SENSOR |
![]() ![]() |
Disconnect the connector.
Disconnect the hose and remove the sensor.







