REMOVAL
Removal / installation · Vehicles built from Sep 2011
| 1. REMOVE NO. 2 INSTRUMENT PANEL FINISH PANEL CUSHION |
Place protective tape as shown in the illustration.

Using a moulding remover, detach the 7 claws and remove the panel cushion.
| 2. REMOVE LOWER INSTRUMENT PANEL PAD SUB-ASSEMBLY LH |
Remove the clip.

Remove the screw.
Detach the 8 claws.
Remove the panel pad and disconnect the connectors and 2 clamps.
| 3. REMOVE NO. 1 INSTRUMENT PANEL FINISH PANEL CUSHION |
Place protective tape as shown in the illustration.

Using a moulding remover, detach the 7 claws and remove the panel cushion.
| 4. REMOVE LOWER INSTRUMENT PANEL PAD SUB-ASSEMBLY RH |
Remove the clip.

Remove the screw.
Detach the 7 claws and remove the panel.
| 5. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY |
Twist the shift lever knob in the direction indicated by the arrow and remove it.


| 6. REMOVE LOWER CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY |
Detach the 7 claws.

Disconnect the connectors and remove the panel.
| 7. REMOVE REAR UPPER CONSOLE PANEL SUB-ASSEMBLY |
Detach the 9 claws and remove the panel.

| 8. REMOVE CONSOLE CUP HOLDER BOX SUB-ASSEMBLY |
Detach the 4 claws and remove the box.

| 9. REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY |
Detach the 14 claws.

Disconnect the connectors and remove the console panel.
| 10. REMOVE REAR CONSOLE END PANEL SUB-ASSEMBLY |
Place protective tape as shown in the illustration.

Using a moulding remover, detach the 8 claws.
Remove the end panel and disconnect the connectors and 2 clamps.
| 11. REMOVE REAR CONSOLE BOX SUB-ASSEMBLY |


Remove the 4 bolts and 2 screws.
Detach the 2 claws and remove the console box.
