REASSEMBLY
Removal / installation · Vehicles built Sep 2011 – Dec 2011
- NOTICE:
- Do not disconnect the hoses indicated in the illustration.
| 1.
INSTALL NO. 1 FUEL SUCTION SUPPORT |
 |
- Attach the 2 claws to the claw holes to install the fuel suction support.
| 2.
INSTALL FUEL PUMP |
 |
- Connect the fuel pump wire harness connector to the fuel pump.
- Apply a light coat of gasoline to a new O-ring. Then install the spacer and O-ring to the fuel pump.
- Attach the 5 claws to the claw holes and install the fuel pump to the fuel filter case.
| 3.
INSTALL NO. 1 FUEL SUB-TANK |
 |
- NOTICE:
- Make sure that the fuel tube passes into the section marked by the circle.
- Attach the 3 claws to the claw holes and install the fuel sub-tank.
- Attach the 3 claws to the claw holes.
- Install the tube part to the sub-tank.
Attach the claw on the end of the tube to the claw hole. Install the tube to the 2 clamps on the sub-tank.
Connect the jet pump to the sub-tank.
- Connect the fuel pump connector.
| 4.
INSTALL FUEL SENDER GAUGE ASSEMBLY
|
 |
- Set the sender gauge to the fuel sub-tank. Then slide the sender gauge downward to install it.
- Connect the fuel sender gauge connector.