2011-2013 Land Cruiser · Service Manual Engine / Hybrid / EV System

REASSEMBLY

Removal / installation · Vehicles built from Sep 2011


NOTICE:
A237022
Do not disconnect the hoses indicated in the illustration.


1. INSTALL NO. 1 FUEL SUCTION SUPPORT
  1. Attach the 2 claws to the claw holes to install the fuel suction support.


2. INSTALL FUEL MAIN VALVE ASSEMBLY

  1. A097616E15
    Apply a light coat of gasoline to 2 new O-rings, and install them onto the fuel main valve.
    Text in Illustration 
    *1
    New O-Ring

  1. Install the fuel main valve to the fuel filter case.

    NOTICE:
    Make sure the O-rings are not cut or pinched during the installation.


3. INSTALL FUEL PUMP
  1. Connect the fuel pump wire harness connector to the fuel pump.

  1. A175046E02
    Apply a light coat of gasoline to a new O-ring. Then install the O-ring and spacer to the fuel pump.
    Text in Illustration 
    *1
    O-Ring
    *2
    Spacer

  1. Attach the 5 claws to the claw holes and install the fuel pump to the fuel filter case.


4. INSTALL NO. 1 FUEL SUB-TANK

A184234E02

NOTICE:
Make sure that the fuel tube passes into the section marked by the circle.

Text in Illustration 
*1
Fuel Tube
  1. Attach the 3 claws to the claw holes and install the fuel sub-tank.

  1. A176343E02
    Connect the jet pump (labeled B) to the sub-tank.
    Text in Illustration 
    *1
    Jet Pump

    1. Attach the claw on the end of the tube to the claw hole.

  1. Connect the jet pump (labeled A) to the sub-tank.

  1. Connect the fuel pump connector.


5. INSTALL FUEL SENDER GAUGE ASSEMBLY

  1. A175048E02
    Set the sender gauge to the fuel sub-tank. Then slide the sender gauge downward to install it.
    Text in Illustration 
    *a
    Slide

  1. Connect the fuel sender gauge connector.

← INSPECTION (from Sep 2011)INSTALLATION (Sep 2011 – Dec 2011) →