2011-2013 Land Cruiser · Service Manual Engine / Hybrid / EV System

REASSEMBLY

Removal / installation · Vehicles built from Sep 2011


NOTICE:
Do not disconnect the hoses indicated in the illustration.
A181363E01


1. INSTALL FUEL PUMP (for Double Tank Type)

  1. A175091
    Connect the fuel pump wire harness connector to the fuel pump.

  1. A176341E01
    Apply a light coat of gasoline to a new O-ring. Then install the spacer and O-ring to the fuel pump.

  1. A175090
    Attach the 2 claws to the claw holes to install the fuel pump.


2. INSTALL NO. 1 FUEL SUB-TANK (for Single Tank Type)

  1. A176405
    Attach the 3 claws to the claw holes to install the fuel sub-tank.


3. INSTALL NO. 1 FUEL SUB-TANK (for Double Tank Type)

  1. A175089
    Attach the 3 claws to the claw holes to install the fuel sub-tank.

  1. A175095E01
    Attach the jet pump to the sub-tank.

    HINT:
    Make sure the 2 protrusions of the jet pump are properly installed into the sub-tank.

  1. A175038
    Connect the fuel pump connector.


4. INSTALL FUEL SENDER GAUGE ASSEMBLY

  1. A175048E01
    Set the sender gauge to the fuel sub-tank. Then slide the sender gauge downward to install it.

  1. A181433
    Connect the fuel sender gauge connector.

← INSPECTION (from Sep 2011)INSTALLATION (Sep 2011 – Dec 2011) →