2011-2013 Land Cruiser · Service Manual Engine / Hybrid / EV System

REASSEMBLY

Removal / installation · Vehicles built Sep 2011 – Dec 2011


NOTICE:
A181361
Do not disconnect the hoses indicated in the illustration.


1. INSTALL NO. 1 FUEL SUCTION SUPPORT

  1. A175045
    Attach the 2 claws to the claw holes to install the fuel suction support.


2. INSTALL FUEL PUMP

  1. A175042
    Connect the fuel pump wire harness connector to the fuel pump.

  1. A175046E01
    Apply a light coat of gasoline to a new O-ring. Then install the spacer and O-ring to the fuel pump.

  1. A176388E01
    Attach the 5 claws to the claw holes and install the fuel pump to the fuel filter case.


3. INSTALL NO. 1 FUEL SUB-TANK

A184234E01

NOTICE:
Make sure that the fuel tube passes into the section marked by the circle.

  1. A175041
    Attach the 3 claws to the claw holes and install the fuel sub-tank.

  1. A176345
    Attach the 3 claws to the claw holes.

  1. A181399E01
    Install the tube part to the sub-tank.

    1. Attach the claw on the end of the tube to the claw hole. Install the tube to the 2 clamps on the sub-tank.

  1. Connect the jet pump to the sub-tank.

  1. A181431
    Connect the fuel pump connector.


4. INSTALL FUEL SENDER GAUGE ASSEMBLY

  1. A175048E01
    Set the sender gauge to the fuel sub-tank. Then slide the sender gauge downward to install it.

  1. A181433
    Connect the fuel sender gauge connector.

← INSPECTION (Sep 2011 – Dec 2011)INSTALLATION (Sep 2011 – Dec 2011) →