2011-2013 Land Cruiser · Service Manual Engine / Hybrid / EV System

INSTALLATION

Removal / installation · Vehicles built from Jan 2012

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012


1. INSTALL FUEL SUCTION WITH PUMP AND GAUGE TUBE ASSEMBLY
  1. Apply a light coat of gasoline or grease to a new gasket, and install it to the fuel tank.

  1. A176324E02
    Install the fuel suction with pump and gauge tube into the fuel tank.
    Text in Illustration 
    *1
    Protrusion
    *2
    Groove
    V100135
    Front

    NOTICE:
    Be careful not to bend the arm of the fuel sender gauge.

    HINT:
    Align the protrusion of the fuel suction with pump and gauge tube with the groove of the fuel tank.

  1. Put the retainer on the fuel tank. While holding the fuel suction with pump and gauge tube, tighten the retainer 1 complete turn by hand.

  1. A242908E01
    Set SST on the retainer.
    SST
    09808-14030  

    HINT:
    1. Hold the fuel suction tube assembly upright by hand to ensure that the fuel suction tube gasket is not moved out of position.
    2. Securely attach the claws of SST to the protrusions of the retainer and fix SST in place.
    3. Install SST while pressing the claws of SST against the retainer (toward the center of SST).

  1. A242906E01
    Using SST, tighten the retainer until the mark on the retainer is within range A on the fuel tank as shown in the illustration.
    SST
    09808-14030  

    HINT:
    Fit the tips of SST onto the ribs of the retainer.


2. INSTALL FUEL TANK SUB-ASSEMBLY
(Click here)
← INSTALLATION (Sep 2011 – Dec 2011)COMPONENTS (Sep 2011 – Dec 2011) →