2011-2013 Land Cruiser · Service Manual Vehicle Exterior

ON-VEHICLE INSPECTION

Inspection · Vehicles built from Sep 2011


INSPECT AUTOMATIC LIGHT CONTROL SENSOR

  1. E146012E02
    Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    M2-6 (CLTB) - M2-3 (CLTE)
    Engine switch on (IG)
    11 to 14 V

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    M2-3 (CLTE) - Body ground
    Always
    Below 1 Ω

  1. Reconnect the M2 sensor connector.

  1. E162670E01
    Check the waveform of the M2 sensor connector.

    Waveform:
    Tester Connection
    Tool Setting
    Switch Condition
    Specified Condition
    M2-3 (CLTE) - M2-5 (CLTS)
    5 V/DIV., 5 msec./ DIV.
    Engine switch on (IG), Headlight dimmer switch on AUTO
    Correct waveform is as shown

    HINT:
    If the ambient light becomes brighter, width A becomes narrower.
    If the result is not as specified, there may be a malfunction in the sensor.

← COMPONENTS (from Sep 2011)REMOVAL (Sep 2011 – Dec 2011) →