2011-2013 Land Cruiser · Service Manual Engine / Hybrid / EV System

REMOVAL

Removal / installation · Vehicles built Sep 2011 – Dec 2011

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012


1. DISCHARGE FUEL SYSTEM PRESSURE
(Click here)

2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).


3. REMOVE SPARE TIRE

4. REMOVE TAILPIPE ASSEMBLY
  1. Remove the bolt, clamp and gasket.

  1. Remove the tailpipe from the 2 exhaust pipe supports.

  1. Remove the bolt and clamp, and then disconnect the tailpipe from the center exhaust pipe.


5. REMOVE SPARE WHEEL CARRIER CROSSMEMBER AND SPARE WHEEL CARRIER BRACKET

  1. Remove the bolt labeled A, and then loosen the 4 bolts labeled B.

    A176384E01

  1. Slightly raise the spare wheel carrier crossmember, and then remove the 6 bolts labeled C, spare wheel carrier crossmember and 2 brackets.


6. REMOVE NO. 1 SPARE WHEEL STOPPER

  1. A176385
    Remove the 2 bolts and spare wheel stopper.


7. REMOVE FUEL TANK CAP ASSEMBLY

8. DISCONNECT FUEL TANK EVAPORATION VENT TUBE SUB-ASSEMBLY

  1. A176420
    Disconnect the 2 fuel tank evaporation vent tubes.


9. DISCONNECT FUEL HOSE

A176421

10. DISCONNECT FUEL TANK BREATHER HOSE

  1. A175076
    Disconnect the breather hose from the filler pipe.


11. DISCONNECT NO. 3 FUEL HOSE

  1. A175077
    Disconnect the fuel hose from the filler pipe.


12. DISCONNECT FUEL TANK TO FILLER PIPE HOSE

  1. A175078
    Disconnect the hose from the filler pipe.


13. REMOVE FUEL SUB TANK SUB-ASSEMBLY

  1. A181396
    Disconnect the floor No. 3 wire connector.

  1. Using a clip remover, detach the 3 wire harness clamps.

  1. Set a transmission jack underneath the fuel sub tank.

  1. A175079
    Remove the 2 bolts and disconnect the 2 fuel tank bands.

  1. Remove the fuel sub tank.


14. REMOVE FLOOR NO. 3 WIRE

  1. A175080
    Disconnect the sender gauge connector.

  1. Using a clip remover, detach the wire harness clamp.


15. REMOVE FUEL SENDER GAUGE ASSEMBLY

  1. A175087
    Remove the 5 screws and sender gauge.

    NOTICE:
    Be careful not to bend the arm of the fuel sender gauge.

  1. Remove the gasket from the sender gauge.


16. REMOVE FUEL HOSE

A176322

17. REMOVE FUEL TANK EVAPORATION VENT TUBE SUB-ASSEMBLY

  1. A176323
    Remove the 2 fuel tank evaporation vent tubes.


18. REMOVE FUEL AND EVAPORATION VENT TUBE SUB-ASSEMBLY

  1. A176321
    Remove the 6 bolts and fuel and evaporation vent tube.

  1. Remove the gasket from the fuel and evaporation vent tube.


19. REMOVE FUEL TANK BREATHER HOSE

  1. A175083
    Remove the breather hose from the fuel sub tank.


20. REMOVE NO. 3 FUEL HOSE

  1. A175084
    Remove the fuel hose from the fuel sub tank.


21. REMOVE FUEL TANK TO FILLER PIPE HOSE

  1. A175085
    Remove the hose from the fuel sub tank.

← COMPONENTS (from Sep 2011)REMOVAL (from Jan 2012) →