2011-2013 Land Cruiser · Service Manual Vehicle Exterior

ON-VEHICLE INSPECTION

Inspection · Vehicles built from Sep 2011


INSPECT TURN SIGNAL FLASHER ASSEMBLY

  1. E157045E01
    Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    E19-7 (E) - Body ground
    Always
    Below 1 Ω

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    E19-1 (IG) - E19-7 (E)
    Engine switch on (IG)
    11 to 14 V
    E19-2 (LR) - E19-7 (E)
    Hazard warning switch off
    Below 1 V
    Hazard warning switch on
    11 to 14 V
    E19-3 (LL) - E19-7 (E)
    Hazard warning switch off
    Below 1 V
    Hazard warning switch on
    11 to 14 V
    E19-4 (B) - E19-7 (E)
    Always
    11 to 14 V
    E19-5 (EL) - E19-7 (E)
    Headlight dimmer switch (TURN L) off
    9 V or higher
    Headlight dimmer switch (TURN L) on
    Below 1 V
    E19-6 (ER) - E19-7 (E)
    Headlight dimmer switch (TURN R) off
    9 V or higher
    Headlight dimmer switch (TURN R) on
    Below 1 V
    E19-8 (HAZ) - E19-7 (E)
    Hazard warning switch off
    9 V or higher
    Hazard warning switch on
    Below 1 V

    If the result is not as specified, there may be a malfunction in the turn signal flasher.

← COMPONENTS (from Sep 2011)REMOVAL (Sep 2011 – Dec 2011) →