2011-2013 Land Cruiser · Service Manual Drivetrain

REPLACEMENT

Removal / installation · Vehicles built from Sep 2011


1. DRAIN MANUAL TRANSMISSION OIL

C172955
  1. Remove the drain plug and gasket and then drain the manual transmission oil.

  1. C174902
    Remove the filler plug and gasket.

  1. Install a new gasket and the drain plug.

    Torque:
    37 N*m{ 380 kgf*cm , 27 ft.*lbf }


2. ADD MANUAL TRANSMISSION OIL

3. INSPECT TRANSMISSION OIL
  1. Park the vehicle in a level place.

  1. D025304E33
    Check that the oil level is within 5 mm (0.196 in.) of the lowest point of the transmission filler plug opening.

    NOTICE:
    1. Problems may occur when the oil level is too high or low.
    2. After replacing the oil, drive the vehicle and check the oil level again.

  1. Inspect for oil leaks when the oil level is low.

  1. C174902
    Install a new gasket and the filler plug.

    Torque:
    37 N*m{ 380 kgf*cm , 27 ft.*lbf }

← COMPONENTS (from Sep 2011)COMPONENTS (from Sep 2011) →