2011-2013 Land Cruiser · Service Manual Vehicle Exterior

ON-VEHICLE INSPECTION

Inspection · Vehicles built from Sep 2011


INSPECT TURN SIGNAL FLASHER ASSEMBLY

E157045E01
  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    1 (IG) - 7 (E)
    Engine switch on (IG)
    11 to 14 V
    2 (LR) - 7 (E)
    Hazard warning switch off
    Below 1 V
    Hazard warning switch on
    11 to 14 V
    3 (LL) - 7 (E)
    Hazard warning switch off
    Below 1 V
    Hazard warning switch on
    11 to 14 V
    4 (B) - 7 (E)
    Always
    11 to 14 V
    5 (EL) - 7 (E)
    Headlight dimmer switch (Turn L) off
    9 V or higher
    Headlight dimmer switch (Turn L) on
    Below 1 V
    6 (ER) - 7 (E)
    Headlight dimmer switch (Turn R) off
    9 V or higher
    Headlight dimmer switch (Turn R) on
    Below 1 V
    8 (HAZ) - 7 (E)
    Hazard warning switch off
    9 V or higher
    Hazard warning switch on
    Below 1 V

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    7 (E) - Body ground
    Always
    Below 1 Ω

    If the result is not as specified, there may be a malfunction in the turn signal flasher.

← COMPONENTS (from Sep 2011)REMOVAL (Sep 2011 – Dec 2011) →