2011-2013 Land Cruiser · Service Manual Engine / Hybrid / EV System

ON-VEHICLE INSPECTION

Inspection · Vehicles built from Sep 2011


INSPECT STARTER RELAY

  1. B060778E26
    Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    3 - 5
    Battery voltage not applied to terminals 1 and 2
    10 kΩ or higher
    Battery voltage applied to terminals 1 and 2
    Below 1 Ω

    If the result is not as specified, replace the starter relay.


INSPECT STARTER CUT RELAY

  1. B060778E26
    Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    3 - 5
    Battery voltage not applied to terminals 1 and 2
    10 kΩ or higher
    Battery voltage applied to terminals 1 and 2
    Below 1 Ω

    If the result is not as specified, replace the starter relay.


INSPECT MAIN BODY ECU (ACC RELAY)

A180124E02
Text in Illustration 
*a
Component without harness connected
(Main Body ECU)
-
-
  1. Measure the resistance of the ACC relay circuit.

    1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance:
      Tester Connection
      Condition
      Specified Condition
      2A-1 - 2D-8
      Battery voltage not applied between 2D-45 and 2D-62
      10 kΩ or higher
      Battery voltage applied between 2D-45 and 2D-62
      Below 1 Ω

      If the result is not as specified, replace the main body ECU.

← INSTALLATION (from Sep 2011)PARTS LOCATION (Sep 2011 – Dec 2011) →