ON-VEHICLE INSPECTION
Inspection · Vehicles built from Sep 2011
| INSPECT STARTER RELAY (ST) |
Measure the resistance according to the value(s) in the table below.

- Standard Resistance:
Tester Connection
Condition
Specified Condition
3 - 5
Battery voltage not applied to terminals 1 and 2
10 kΩ or higher
Battery voltage applied to terminals 1 and 2
Below 1 Ω
| INSPECT STARTER CUT RELAY (ST CUT) |
Measure the resistance according to the value(s) in the table below.

- Standard Resistance:
Tester Connection
Condition
Specified Condition
3 - 5
Battery voltage not applied to terminals 1 and 2
10 kΩ or higher
Battery voltage applied to terminals 1 and 2
Below 1 Ω
| INSPECT MAIN BODY ECU (ACC RELAY) |


Measure the resistance of the ACC relay circuit.
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
2A-1 - 2D-8
Battery voltage not applied between 2D-45 and 2D-62
10 kΩ or higher
Battery voltage applied between 2D-45 and 2D-62
Below 1 Ω
