REMOVAL
Removal / installation · Vehicles built from Sep 2011
- HINT:
- Use the same procedures for the LH side and RH side.
- The procedures listed below are for the LH side.
- Use the same procedures for the LH side and RH side.
| 1. REMOVE STABILIZER CONTROL VALVE PROTECTOR (w/ KDSS) |
![]() ![]() |
Detach the clamp, and disconnect the connector from the protector.
Remove the 3 bolts and protector.
| 2. OPEN STABILIZER CONTROL WITH ACCUMULATOR HOUSING SHUTTER VALVE (w/ KDSS) |
Using a 5 mm hexagon socket wrench, loosen the lower and upper chamber shutter valves of the stabilizer control with accumulator housing 2.0 to 3.5 turns.


- NOTICE:
- When loosening a shutter valve, make sure that the end protrudes 2 to 3.5 mm (0.0787 to 0.137 in.) from the surface of the block, and do not turn the shutter valve any further.
- Do not remove the shutter valves.
- When loosening a shutter valve, make sure that the end protrudes 2 to 3.5 mm (0.0787 to 0.137 in.) from the surface of the block, and do not turn the shutter valve any further.
| 3. REMOVE FRONT WHEEL |
| 4. DISCONNECT FRONT DISC BRAKE CALIPER ASSEMBLY LH |
Remove the bolt and nut, and disconnect the brake tube bracket from the steering knuckle.

Remove the 2 bolts and disconnect the disc brake caliper from the steering knuckle.

- NOTICE:
- Do not disconnect the flexible hose from the disc brake caliper.
- Do not twist or bend the flexible hose.
- Do not disconnect the flexible hose from the disc brake caliper.
| 5. REMOVE FRONT DISC |
| 6. REMOVE FRONT AXLE HUB GREASE CAP LH |
Using a screwdriver and hammer, remove the axle hub grease cap.

- NOTICE:
- Do not damage the axle hub.
| 7. REMOVE FRONT AXLE SHAFT NUT LH |
Remove the cotter pin and adjusting lock cap.

Using a 39 mm socket wrench, remove the axle hub nut.

| 8. REMOVE FRONT AXLE HUB SUB-ASSEMBLY LH |
Remove the 4 bolts.

Using SST, remove the front axle hub together with the dust cover.

- SST
- 09950-40011
(09951-04020, 09952-04010, 09953-04020, 09954-04010, 09955-04061, 09957-04010, 09958-04011)
Remove the O-ring.

