2011-2013 Land Cruiser · Service Manual Vehicle Interior

INSPECTION

Inspection · Vehicles built from Sep 2011


INSPECT COOLER CONTROL SWITCH SUB-ASSEMBLY

  1. B188370E01
    Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    1 - 2
    On
    Below 1 Ω
    1 - 2
    Off
    10 kΩ or higher

  1. Apply battery voltage to the cooler control switch connector and check that the indicator illuminates.

    OK:
    Measurement Condition
    Specified Condition
    Battery positive (+) → Terminal 3
    Battery negative (-) → Terminal 4
    indicator illuminates

    If the result is not as specified, replace the cooler control switch.


INSPECT NO. 1 COOLER BLOWER MOTOR SUB-ASSEMBLY

B188371E01
  1. Apply battery voltage to the blower motor connector and check the operation of the blower motor.

    OK:
    Measurement Condition
    Specified Condition
    Battery positive (+) → Terminal 1
    Battery negative (-) → Terminal 2
    Motor operates smoothly

    If the result is not as specified, replace the blower motor.


INSPECT NO. 3 COOLER THERMISTOR

  1. B185166E01
    Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    1 - 2
    -10°C (14°F)
    7.40 to 9.20 kΩ
    1 - 2
    -5°C (23°F)
    5.65 to 7.00 kΩ
    1 - 2
    0°C (32°F)
    4.35 to 5.40 kΩ
    1 - 2
    5°C (41°F)
    3.40 to 4.20 kΩ
    1 - 2
    10°C (50°F)
    2.68 to 3.30 kΩ
    1 - 2
    15°C (59°F)
    2.10 to 2.60 kΩ
    1 - 2
    20°C (68°F)
    1.66 to 2.10 kΩ
    1 - 2
    25°C (77°F)
    1.32 to 1.66 kΩ
    1 - 2
    30°C (86°F)
    1.05 to 1.35 kΩ

    NOTICE:
    1. Even slightly touching the sensor may change the resistance value. Be sure to hold the connector of the sensor.
    2. When measuring, the sensor temperature must be the same as the ambient temperature.

    HINT:
    1. As the temperature increases, the resistance decreases (see the graph).
    2. If the result is not as specified, replace the cooler thermistor.

← DISASSEMBLY (from Jan 2012)REASSEMBLY (Sep 2011 – Dec 2011) →