2011-2013 Land Cruiser · Service Manual Power Source / Network

U0327 Software Incompatibility with Vehicle Security Control Module

Diagnostic trouble codes · Vehicles built Sep 2011 – Dec 2011

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012

DESCRIPTION

DTC Code
DTC Detection Condition
Trouble Area
U0327
There is no communication from the certification ECU (smart key ECU assembly).
  1. Power source circuit of certification ECU (smart key ECU assembly)
  2. Certification ECU (smart key ECU assembly)
  3. Certification ECU (smart key ECU assembly) branch wire or connector

HINT:
For vehicles with the entry and start system only.


WIRING DIAGRAM

C176044E07

INSPECTION PROCEDURE

NOTICE:
Inspect the fuses for circuits related to this system before performing the following inspection procedure.

HINT:
Operating the ignition switch, any switches or any doors triggers related ECU and sensor communication with the CAN, which causes resistance variation.


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
  1. Disconnect the cable from the negative (-) battery terminal before measuring the resistances of the main wire and the branch wire.

    CAUTION:
    For vehicles with an SRS system:
    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    NOTICE:
    When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).


NEXT


2. CHECK FOR OPEN IN CAN BUS WIRE (CERTIFICATION ECU BRANCH WIRE)
C150952E07
  1. Disconnect the E29 certification ECU (smart key ECU assembly) connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    E29-27 (CANH) - E29-28 (CANL)
    Ignition switch off
    54 to 69 Ω



NG
REPAIR OR REPLACE CERTIFICATION ECU (SMART KEY ECU ASSEMBLY) BRANCH WIRE OR CONNECTOR (CANH, CANL)
OK


3. CHECK HARNESS AND CONNECTOR (CERTIFICATION ECU - BATTERY AND BODY GROUND)
C150952E11
  1. Connect the cable to the negative (-) battery terminal.

    NOTICE:
    When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    E29-17 (E) - Body ground
    Always
    Below 1 Ω

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    E29-1(+B) - Body ground
    Always
    11 to 14 V
    E29-19 (ACC) - Body ground
    Ignition switch ACC
    11 to 14 V
    E29-18 (IG) - Body ground
    Ignition switch ON
    11 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE CERTIFICATION ECU (SMART KEY ECU ASSEMBLY)


← U0230 Lost Communication with Rear Gate Module (from Jan 2012)U0327 Software Incompatibility with Vehicle Security Control Module (from Jan 2012) →