2011-2013 Land Cruiser · Service Manual Suspension

REMOVAL

Removal / installation · Vehicles built from Sep 2011

HINT:
  1. Use the same procedures for the RH side and LH side.
  2. The procedures listed below are for the LH side.


1. REMOVE STABILIZER CONTROL VALVE PROTECTOR (w/ KDSS)

C172095
  1. Detach the clamp, and disconnect the connector from the protector.

  1. Remove the 3 bolts and protector.


2. OPEN STABILIZER CONTROL WITH ACCUMULATOR HOUSING SHUTTER VALVE (w/ KDSS)

  1. Using a 5 mm hexagon socket wrench, loosen the lower and upper chamber shutter valves of the stabilizer control with accumulator housing 2.0 to 3.5 turns.

    C175131E01

    NOTICE:
    1. When loosening a shutter valve, make sure that the end protrudes 2 to 3.5 mm (0.0787 to 0.137 in.) from the surface of the block, and do not turn the shutter valve any further.
    2. Do not remove the shutter valves.


3. REMOVE REAR WHEEL

4. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL (w/ Active Height Control)

5. REMOVE REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY LH (w/ Active Height Control)

  1. C176365
    Disconnect the connector and 2 clamps.

  1. C172823
    Remove the 2 bolts, nut and sensor.


6. DISCONNECT SPEED SENSOR WIRE HARNESS

  1. C174362
    Remove the bolt and disconnect the speed sensor wire harness from the upper control arm.


7. REMOVE REAR STABILIZER CONTROL TUBE INSULATOR (w/ KDSS)

  1. C174360
    Remove the 2 bolts and rear stabilizer control tube insulator.


8. REMOVE UPPER ARM BUSH HEAT INSULATOR (w/o KDSS)

  1. C180039
    Remove the bolt and upper arm bush heat insulator.


9. SUPPORT REAR AXLE HOUSING ASSEMBLY

  1. C174050
    Support the rear axle housing with a jack using a wooden block to avoid damage.


10. REMOVE REAR UPPER CONTROL ARM ASSEMBLY LH (w/ Active Height Control)

  1. C174363
    Remove the 2 nuts, 2 washers, 2 bolts and upper control arm.


11. REMOVE REAR UPPER CONTROL ARM ASSEMBLY LH (w/o Active Height Control)

  1. C178733
    Remove the 2 nuts, 2 washers, 2 bolts and upper control arm.

← COMPONENTS (from Sep 2011)INSTALLATION (from Sep 2011) →