2011-2013 Land Cruiser · Service Manual Suspension

REMOVAL

Removal / installation · Vehicles built from Sep 2011


1. REMOVE STABILIZER CONTROL VALVE PROTECTOR (w/ KDSS)

C172095
  1. Detach the clamp, and disconnect the connector from the protector.

  1. Remove the 3 bolts and protector.


2. OPEN STABILIZER CONTROL WITH ACCUMULATOR HOUSING SHUTTER VALVE (w/ KDSS)

  1. Using a 5 mm hexagon socket wrench, loosen the lower and upper chamber shutter valves of the stabilizer control with accumulator housing 2.0 to 3.5 turns.

    C175131E01

    NOTICE:
    1. When loosening a shutter valve, make sure that the end protrudes 2 to 3.5 mm (0.0787 to 0.137 in.) from the surface of the block, and do not turn the shutter valve any further.
    2. Do not remove the shutter valves.


3. SUPPORT REAR AXLE HOUSING ASSEMBLY

  1. C174050
    Support the rear axle housing with a jack using a wooden block to avoid damage.


4. REMOVE REAR LATERAL CONTROL ROD ASSEMBLY

  1. C178873
    Remove the 2 bolts, nut, washer and lateral control rod.

← COMPONENTS (from Sep 2011)INSTALLATION (from Sep 2011) →