2011-2013 Land Cruiser · Service Manual Vehicle Exterior

REMOVAL

Removal / installation · Vehicles built from Jan 2012

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012

HINT:
When removing the back door garnish, heat the back door garnish and vehicle body using a heat light.

Standard Heating Temperature:
Item
Temperature
Back Door Garnish
20 to 30°C (68 to 86°F)
Vehicle Body
40 to 60°C (104 to 140°F)

NOTICE:
Do not heat the back door garnish and vehicle body excessively.


1. REMOVE BACK DOOR GARNISH SUB-ASSEMBLY OUTSIDE RH
  1. Put protective tape around the back door garnish.

  1. Detach the 7 clips and remove the double-sided tape to remove the back door garnish.

    B186236E01


2. REMOVE SYMBOL EMBLEM

B185937E01
  1. Put protective tape around the emblem.

  1. Insert a piano wire between the vehicle body and emblem.

    HINT:
    Be careful of the boss position.

  1. Tie objects that can serve as handles (for example, wooden blocks) to both wire ends.

  1. Pull the piano wire and scrape off the double-sided tape that holds the emblem to the vehicle body.

    NOTICE:
    Be careful not to damage the vehicle body.

  1. Remove the emblem.


3. REMOVE REAR FLOOR MAT REAR SUPPORT PLATE

B181672
  1. Detach the 6 clips and remove the support plate.


4. REMOVE BACK DOOR TRIM COVER LH

  1. B313304
    Remove the back door trim cover LH as shown in the illustration.


5. REMOVE BACK DOOR TRIM COVER RH

  1. B313305
    Remove the back door trim cover RH as shown in the illustration.


6. REMOVE BACK DOOR TRIM PANEL ASSEMBLY

  1. B181336
    Remove the 4 bolts.

  1. Detach the 16 clips and remove the back door trim panel assembly.


7. REMOVE NO. 2 BACK DOOR GARNISH SUB-ASSEMBLY OUTSIDE

B186238
  1. Remove the 2 nuts and disconnect the connector.

  1. Put protective tape around the No. 2 back door garnish.

  1. Detach the 8 clips.

  1. Pull out the wire harness of the license plate light from the tail gate, and remove the No. 2 back door garnish.

    B186239E01


8. REMOVE LICENSE PLATE LIGHT ASSEMBLY

  1. E156994
    Remove the 2 screws and 2 lights.


9. REMOVE REAR LICENSE LIGHT COVER

B188295E01
  1. Put protective tape around the rear license light cover.

  1. Detach the 7 claws and remove the double-sided tape to remove the rear license light cover.

← REMOVAL (Sep 2011 – Dec 2011)INSTALLATION (Sep 2011 – Dec 2011) →