DISPOSAL
Removal / installation · Vehicles built from Sep 2011
- HINT:
- Use the same procedures for the LH side and RH side
- The procedures listed below are for the LH side.
- Use the same procedures for the LH side and RH side
| 1. DISPOSE OF NO. 2 SEAT STAY SUB-ASSEMBLY |
![]() ![]() |
Horizontally fix the seat stay in a vise with the piston-rod pulled out.
Wear safety glasses. Gradually cut a part between A and B shown in the illustration using a metal saw and gradually release the gas.
- Standard:
Area
Specified Condition
a
80 mm (3.15 in.)
b
10 mm (0.394 in.)
- CAUTION:
- As metal debris may be blown outward by the gas, you must:
- Wear protective glasses.
- Cover the area being cut.
- Wear protective glasses.
- NOTICE:
- The gas inside the seat stay is colorless, odorless and harmless. There is a possibility that metal debris could scatter, so cover the part with a piece of cloth or other material.


